Console House 10 Mode Instructions d'exploitation télécharger pdf (Page 47)

For an energy saver module, the status shows the current temperature,

the heating and cooling setpoints, the energy saver on/off status, and

the time remaining for any timed on/off command:

Upstairs TEMP: 78

HEAT: 70 COOL: 78

↓

Upstairs 00:00:30

ENERGY SAVER: OFF

↑

For a temperature sensor, the status shows the current temperature and

the Low and High setpoints:

Outdoor TEMP: 85

LOW: 70 HIGH: 80

When you are finished, press the ' * ' key twice to return to the

top-level display.

IMPORTANT NOTES:

- There is a 3 minute minimum on and off time for PESMs

designed to prevent short cycling your HVAC compressor. If the

PESM has just turned the HVAC system on or off, it will wait 3

minutes before changing it, even though the display does change.

- If you change the Heat or Cool setback temperature on the

Model 1101 PESM, the system will insure that there is always at

least four degrees Fahrenheit difference between the Heat and

Cool temperatures by altering the other setback temperature as

necessary.

- PESMs are not affected by All On or All Off commands.

PESMs can also be used to report potential freeze conditions before

damage to pipes and appliances can occur. An alarm will be

generated if a temperature below 40 degrees is detected by any PESM

in the system. The alarm will not clear until the temperature exceeds

45 degrees.

Freeze Alarm

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 135 136

Pas de commentaire

Console House 10 Mode Instructions d'exploitation Page 47