Console House 10 Mode Instructions d'exploitation télécharger pdf (Page 24)

User code 1 is always set to a Master code - See Set Up Codes.

The Manager codes can arm/disarm the security system in assigned

areas, during assigned times. The Manager code can access functions

that are code protected in High Security mode. Managers may also

access the system from an outside telephone line.

User codes can only be used to arm and disarm the security system in

assigned areas when the time assigned to that code is valid.

If you are forced to disarm the system against your will by an intruder,

disarm it as you normally would, but use the Duress code instead of

your normal code. The system will disarm normally. No sirens will

sound, no lights will flash, but the Omni will perform a silent dial out

and say that this is a silent alarm.

To stop a silent dial out, turn your security system off the usual way,

pressing OFF key, then your code.

If you have had panic switches installed, they are always armed.

Pressing a panic switch will cause the alarm to sound inside and

outside immediately. This alarm can only be silenced by pressing the

OFF key and a valid code on the console.

If your installer has enabled the Area feature, the security system may

be armed in Area 1, and disarmed in Area 2. In fact, each area may be

armed in different security modes at the same time. Each area will

have its own console that will control that area independently from the

other.

When disarming the security system or arming the security system in

any mode, the system will automatically control all security functions

in the area of that console if your code is valid for that area.

Manager Code

User Code

Duress Code

Panic Switches

Area Arming

24 Omni Owner's Manual

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 135 136

Pas de commentaire

Console House 10 Mode Instructions d'exploitation Page 24