Console House 10 Mode Instructions d'exploitation télécharger pdf (Page 14)

Note that there is an exit delay before the system is armed in any

mode. The bypass will only take place if the zone is not ready when

the exit delay is over and the system actually arms itself.

When a zone is Auto-Bypassed, it will be automatically restored the

next time you arm or disarm the system. The auto-bypass is recorded

in the event log as "ZONE NAME BYPASSED".

To prevent any zone from being bypassed unintentionally, you should

always look for "SYSTEM OK" on the display before arming and

leaving the premises.

When arming a different area, in Auto-Bypass mode, all zones in that

area must be ready. If any zones are not ready, you must manually

Bypass those zones before arming that area.

The Auto-Bypass feature can be disabled if you do not want the system

to automatically bypass open zones. If the auto-bypass feature is

disabled, the alarm will sound if a zone is open and the system is

armed.

NOTE: The Auto-Bypass feature is disabled on UL Listed

Installations.

9 = RESTORE

Restoring a zone puts it back on active duty in the system. When

restored, the Bypassed indication will no longer be displayed on the

status line and the zone will be checked for alarm and trouble

conditions.

To restore a zone, from the top-level display, press 2 on the console

keypad, then 9 for restore.

Enter the zone number followed by the ' # ' key, or use the arrow keys

to select the zone. Press ' 0 ' as the first key to restore all zones. The

0 = ALL choice is removed once a digit key or the down arrow is

pressed. After the zone or all zones is entered, you will be prompted

to enter your code.

Restoring Zones

14 Omni Owner's Manual

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 135 136

Pas de commentaire

Console House 10 Mode Instructions d'exploitation Page 14